I had this dress hanging in my closet, and I loved the print on the fabric, but the something about the length just bothered me. It fell to a place somewhere between the knee and ankle that just felt awkward to me. Hemming up a dress to make it a little shorter is not a difficult task so I decided to make it a little more interesting by following the bottom edges of the print to make it a scalloped hem.
Luckily, the print could be seen clearly on the inside of the dress (the wrong side of the fabric). All that needed to be done was to fold up the bottom edge towards the right side, and stitch along the scalloped edge from the wrong side. (the edge to the right is the fold, and the original hem is folded underneath)
You can see the original hem at the top left here. Next I clipped the fabric from the fold up to the point between each scallop all the way around the skirt. I cut as close to the stitching line as I could without cutting the thread.
I used my pinking shears to cut around each scallop instead of clipping hundreds of tiny notches individually. Trimming it this way is very important though, because a curved seam will not sit properly unless it has been clipped. (You can read more about clipping seam allowances here)
The last steps were to turn the scallops out the right way, press the seams, and finally stitch the hem. I simply trimmed off the original hem fabric close to the scallops and did a simple machine blind hem stitch.
In the end I’m much happier with the length, and I think the scalloped edge just adds a fun touch that works with the spirit of the dress.